Swimmer

The Swimmer module swim particles in the detector volume for the latter use by the Smear module to generate the detector signal. The format of the input data is
2cm
where

• [id:] The ID number of the parameter. 1 for the seed of smearing, 2 for the solenoid magnetic field strength in k-gauss. ID should be 0 to terminate the input.
• [value:] The value for the parameter.

The typical example of input data is shown in the Fig. 3. When you change the magnetic field strength, make sure to use same field strength both for Swimmer and Smear.

 

Figure 3:  Example of input data for Swimmer module.