Document of DAQ System
Document in Japanese（にほんご）

Abstruct:
Our DAQ system consists from 3 part.

1)DAQ Configurator(dconf)
2)DAQ program(jlcdaq)
3)On-line monitor software(histoscope)

At first,you should edit configuration of DAQ system by using dconf.
After finishing it,dconf will dump a configuration file which contains data of CAMAC setting up.
Any config file which made by dconf should have a special suffix,".cf".
Next,you must turn on the hardwares,such as CAMAC,NIM,HV supply,and so on.
Then,you can run the jlcdaq,and take a data of calorimeter.
jlcdaq will read the configuration file,and according to it,operate CAMAC modules,and acquire the data.

---

If you have any questions,requests,opinions,or if you find any problems,please tell me.
satoru@hepsg3.px.tsukuba.ac.jp